How far apart should alcove shelves be?
How far apart should alcove shelves be?
(Masonry walls) For shelves taking light weight, space the holes no more than about 450mm (18 inches) apart (with the end holes about 225mm (9 inches) in from the ends) – for heavy loads, space the holes no greater than about 300mm (12 inches) apart (with the end holes about 150mm (6 inches) in from the ends).
What can I do with a small alcove?
Alcove ideas: 15 ways to make the most of a small space
- Build alcove shelving to create a small home office.
- Build in alcove cupboards to display and disguise.
- Fake a built-in look with freestanding alcove cupboards.
- Create a home bar in an alcove.
- Add a pop of colour by painting an alcove.
- Create a library in your alcove.
Should shelves be evenly spaced?
A good average spacing for shelves is between 8 and 12 inches. If you’re storing a combination of large and small books and need to vary the spacing between shelves, keep the wide spacing on the bottom; this prevents the bookshelf from becoming top heavy and tipping over.
How far should shelves be apart?
The rule of thumb for spacing is 12 inches between each shelf but bump that up to 15 or 18 inches and you enhance that sense of exposure and accessibility.
How do you cover alcove?
Simple Ways to Screen Your Alcove Hanging Space
- Doors. If you want the traditional wardrobe look, then fitting your alcove with traditional doors should be your go-to.
- Victorian screen panel.
- Material.
- Stained glass.
- Sliding doors and more.
Should an alcove be painted lighter or darker?
Accentuate. If you want to accentuate your recessed wall with paint, there are a few points to consider. Recessed walls stand out more if they are either darker or lighter than the other walls in the room. Lighter shades will pop in a darker room and can add needed light for rooms with small windows.
Do floating shelves need studs?
Ideally, you should attach floating shelves (or anything else you’re hanging) to a wall stud, as this will give you the most supportive base for your project. A stud finder—a hand-held device that uses a magnet to detect metal, such as the nails and screws in the wall studs of your home—can help you locate these.
Can you put shelves up on plasterboard?
To put up a shelf on a plasterboard wall, you will need to find two studs (a stud is the upright wooden support in the wall to which the plasterboard is attached) to anchor your shelf brackets. Use your stud detector to find them, then draw two vertical guides along the lines of the studs.
Can a shelf be fitted into an alcove?
One great advantage of fitting shelves into an alcove is that battens can usually be fitted to the side walls to support both ends of each shelf leaving each shelf unobstructed by wall brackets etc.
How to put up shelves in alcoves reader’s digest?
Hold the rear batten to the mark with a spirit level on top. Mark the wall through one end hole with the twist bit. Switch to a masonry bit and drill and drill and plug the hole. Drive in a screw part way. 4. Hold the rear batten level and mark the other holes in the same way. 5.
What kind of cabinets are used in alcove?
Another beautiful example of our product – a pair of alcove cabinets with floating shelves above. Cabinets made with traditional shaker beaded doors, plain skirting board at the bottom and finishing 36mm thick countertop with the lip around.
What’s the best way to build an alcove?
Alcoves are often out of square so I take a measurement at each of the four sides. I also use a large roofing square to check which of the back corners are 90° and always start my setting out from a perfectly square corner.
