How do I reset my Simon alarm system?

How do I reset my Simon alarm system?

Complete the following steps to reset an Interlogix Simon XT to factory defaults:

1. Disconnect the battery. Open the back cover of the Simon XT System, and disconnect the backup battery that is connected to the circuit board.
2. Unplug the transformer.
3. Reset the panel.
4. Confirm the reset.
5. Complete the process.

How do I reset my Simon 3 alarm?

to the factory defaults, do the following:

1. Open the Control Panel cover.
2. Unplug the transformer and the battery.
3. Simultaneously press Cancel, Clock Set, and. Minutes.
4. Restore power to the panel with either the battery. or the transformer while pressing these three buttons.
5. Plug in the transformer or connect the battery.

How do you disarm security system without code?

You can turn off or power down your home alarm system by disconnecting its backup battery and then unplugging the transformer for the device from the wall outlet. You can confirm that the panel has been powered down by checking its touchscreen or keypad and making sure that it is blank.

How do I change the code on my Simon XT alarm?

How do I change the user codes directly on my Simon XT Control Panel?

1. Press the Down arrow until you see System Programming on the screen and press OK.
2. Enter your 4-digit master code and press OK.
3. You should see Access Codes displayed on the screen and then press OK.
4. The screen will display your master code.

How do you remove a Simon alarm system?

All wireless sensors have a base; the sensor is removed from the base by depressing the tab and sliding or twisting the sensor. If the double-sided tape will not release, remove the sensor from the base plate and use a standard hair dryer to heat the base or magnet. This allows the glue to soften and release easier.

How do I disarm my alarm code?

When the system is armed, there will be a button on the touchscreen labeled “Disarm”. Click on this button. You will then be prompted to enter in a code….Nevertheless, the default Master Codes for various security systems are as follows:

1. Honeywell Systems: 1234.
2. 2GIG Systems: 1111.
3. Qolsys Systems: 1234.