How wide are Jeep axles?
How wide are Jeep axles?
A full size axle is about 70″ wide.
How wide is a Jeep Wagoneer axle?
Re: Widest Width of Rear Axle and Tire Combo – Wagoneer Stock rear axle is actually 57.5″ WMS for a wagoneer.
How wide is a Jeep Cherokee axle?
Products specifications
| Vehicle Fitment | 1984 thru 2001 Jeep Cherokee XJ |
|---|---|
| Wheel Bolt Pattern | Dual pattern, 5 on 4 1/2” and 5 on 5 ½”, 1/2″ studs installed in 5 on 4 1/2 |
| Brake Space | 2.5 inch axle standoff |
| Width | 60.625 inches (between wheel mounting surfaces) |
| Fluid Capacity | 3 quarts of 85w-140, non-synthetic (API GL-6 rated only) |
How wide is a Jeep Wrangler axle?
At 60 3/4 inches wide, this axle is almost the same width as a TJ (61 1/2 inches, wheel-mounting surface to wheel-mounting surface). They are commonly found with Trac-Lok limited slips and either 4.30 or 4.56 gears.
How wide is a Ford 8.8 axle?
How To Spot, Build, And Swap In the Ford 8.8 Mustang Rearend.
| Vehicle Application | Axle Width (inches) |
|---|---|
| ’86-’93 Ford Mustang 8.8 | 59 11/44 |
| FORD | |
| ’65-’66 Mustang | 57 11/44 |
| ’67-’70 Mustang 8.0 | 59 51/48 |
How much wider are Rubicon axles?
Also, a JL Rubicon has axles that measure an impressive 68″ wide and that make them 1.50″ wider than a Sport or Sahara and a whole 2.50″ wider than a JK. I should note, full width axles typically measure 68.50″!
Is the Ford 8.8 strong?
See all 13 photos The 8.8-inch Ford is an inexpensive alternative to the more expensive rearend choices for the budget-limited Ford performance enthusiast. Ford 8.8 Strength ComparisonThe truth is that the Ford 8.8 is virtually a clone of the Chevy 12-bolt and therefore almost as strong.
What are the dimensions of a jeep axle?
Axle housing diameter = 2.625″ Stock shafts = 27 splines brake drums: 1989 and older = 10″ Drum Axle width, WMS to WMS = 60.75″ (WMS = Wheel Mounting Surfuce) Cover bolts = 10
What’s the gear ratio on a Jeep J XX?
Front axles were closed knuckle Dana 44 until the J-xx. (Wagoneers used Dana 27A’s until ’74). Rears were Dana 44 in 1/2T, Dana 60 in 3/4T and Dana 70 dually in 1T. Standard gear ratios were 3.90 with optional 4.27 & 4.88 in 1/2 & 3/4T models. 1T models came with 4.88 and had 5.89 as an option.
What kind of axle does a jeep 30 have?
Model 30: Drive-type, full floating axle with open end steering knuckles mounted on ball studs. Model 30 Front Axle: CJ-5, CJ-7, Scrambler, YJ, XJ and TJ.
When to change the axle on a jeep?
However, many jeep owners still believe swapping a new, beefier axle is more cost effective and better. As a general rule of thumb, most owners agree that once a jeep has been modified to run 32″ or 33″ tires, it is time to start thinking about upgrading the rear dana 35.
