Does a C6 transmission need a kickdown cable?
Does a C6 transmission need a kickdown cable?
You won’t hurt the C6 by running without a kickdown (or a C4 for that matter) if that’s what your question was. Just downshift manually.
How do you install a kick down cable?
Method 1 of 1: Replacing the kickdown cable
- Materials Needed.
- Step 1: Jack up the front of the vehicle and set the jack stands.
- Step 2: Place wheel chocks on the rear wheels.
- Step 3: Disconnect the kickdown cable at the carburetor or throttle body.
- Step 4: Remove the kickdown cable from the mounting bracket.
How do I install Lokar kickdown cable?
Slide the kickdown cable end stop onto the inner wire. Move the throttle to wide open and hold it there while pulling the kickdown inner wire as tight as possible. Slide the cable end stop up against the kickdown throttle body fitting and tighten the set screw using the supplied 5/64″ Allen wrench.
Do you need a transmission kickdown cable?
In fact, if you don’t mind downshifting manually with the shift lever when passing, there’s really no need for a functional kickdown cable or switch at all. You must install a true TV cable with the correct throttle-lever pivot geometry and then adjust it properly or you will burn up the trans!
Can I drive without a kickdown cable?
Tools R Us said: Shouldn’t be a problem. The cable adjusts system pressure, so shift pressure. With the cable fully retracted it will shift lazy/slip a lot, if the cable was pulled fully out it will shift more firmly, less slip.
What does a kickdown Rod do?
One component that helps both drive systems communicate is the kickdown cable. This device helps the engine relay information on revolutions per minute (RPM) to the automatic transmission and essentially tells it that it’s time to shift gears.
Can you run a 700R4 without a TV cable?
There are no TV cable, mechanical speedometer drive, or governor provisions. To run a 700-R4 trans behind a carbureted engine without a computer, at the very least the TV cable must be hooked up to the carburetor and properly adjusted.
How does a kick down cable work?
The kick down cable is mounted to the carburetor, or, in the case of fuel injected vehicles, the throttle body. It runs from the butterfly arm on the carburetor down to the side of the transmission, where it attaches to an arm that allows the transmission to shift gears.
How does kickdown cable work?
Does a Powerglide have a kickdown cable?
Lokar Hi-Tech Kickdown Kit for GM Powerglide Transmission is designed with a specially extruded liner for extended life of the cable, not to be confused with ordinary brake hose. The kickdown can be mounted with Lokar’s stainless steel carburetor bracket and return springs (which are sold separately).
What does a kickdown cable do on transmission?
Can you run a 700r4 without a TV cable?
Is a kickdown needed with my C6?
C6 doesn’t need the kickdown. Your friend may be thinking of Mopar 727’s, AOD’s that DO need the kickdown (or TV control).
What is a kickdown cable?
This cable, known as the kickdown cable, is used to control what gear the transmission is in. Its function is important for smoother driving, optimum performance, and better emissions, but if the kickdown cable is out of adjustment or not working properly, it can cause premature wear and damage.
What is a transmission kick down Cable?
The transmission kick down cable works to shift the transmission to a higher gear automatically when the engine is revved or otherwise accelerated. A kick down cable comes installed standard on any vehicle, but there are also a variety of aftermarket kick down cables that can be purchased as well.
