How do I reset my Kwikset 910 Z-Wave?

How do I reset my Kwikset 910 Z-Wave?

How to connect and reset a Z-Wave Kwikset lock

1. Remove the batteries.
2. Press and hold the lock button on the keypad.
3. Place the batteries back in (while still holding the button)
4. The lock will beep three times over the course of 15 seconds or so. After the 3rd beep release the button.

How do I factory reset my Kwikset Smart Lock?

A factory reset will delete all codes associated with the lock.

1. Make sure the door is open and unlocked.
2. Press and hold the program button for 30 seconds using the SmartKey tool or a paper clip. You will hear one long beep.
3. Press and release the program button. You will hear one short beep.

How do you change the code on a Kwikset Z-Wave lock?

1. Make sure the door is open. Press the Program button once.
2. Press checkmark symbol once.
3. Enter user code. A total of 16 user codes may be programmed. Each user code must be a unique code between 4 and 8 digits.
4. Press lock symbol once.

What is the master code for Kwikset lock?

0-0-0-0
The default Mastercode is 0-0-0-0. It is recommended that you change it to a code of your own. 1. Make sure the lock is unlocked and the door is open.

How do I reprogram my Kwikset SmartCode?

How do I program my SmartCode 913 lock?

1. Open the door.
2. Remove battery cover.
3. Press the program button once.
4. Enter new user code.
5. Press lock button.
6. If programming is successful the keypad will flash green once, and you will hear one beep.

How do I reset my Z wave door lock?

Complete the following steps to factory default your Kwikset Z-Wave Lock.

1. Remove the cover. Take off the lock’s cover.
2. Power down the lock. Remove the battery pack.
3. Press and hold “Program”. Press and hold the “Program” button.
4. Power on the lock.
5. Wait for confirmation.
6. Finish the reset.

How do I factory reset my Kwikset 913?

Press and hold the program button while reinserting the battery pack. Keep holding the button for 30 seconds until it beeps. Press the program button once more in 20 seconds the LED will flash green and you will hear a beep.

Is there an app to control Z-wave devices?

Z-Wave.Me app allows you to control your smart home based on Z-Wave technology. Control light, heating, door locks and monitor smart home sensors from a single app. This app is compatible with Z-Wave.Me controllers RaZberry, Z-Way and Hub version v3. 0.5 and upper.

How do I reset my Kwikset 910 lock code?

Press and HOLD the Program button while reinserting the battery pack. Keep holding the button for 30 seconds until the lock beeps and the status LED flashes red. Press the Program button once more. When the LED flashes green and you hear one beep, the lock has been reset.

How do you unlock a Kwikset lock code?

To program the first user code:

1. Press the button marked “program button” once.
2. Using the keypad, enter a 4- to 8-digit code.
3. Press the ‘LOCK” button to save the code.
4. Extend the bolt by pressing- the “LOCK” button.
5. Enter the new code number. The bolt should retract.