How to setup WET610N?

How to setup WET610N?

Open the Internet browser and in the address bar type the IP address of wet610n. It will open the setup page. Click on Wireless tab and go to Wireless Network site survey. Select your SSID from the list and try to connect.

What is linksys WET610N?

The Linksys WET610N Dual-Band N Entertainment Bridge lets you connect your Ethernet-enabled devices such as gaming consoles or DVRs to your wireless network. Wireless (Blue) LED – lights up when there is an active wireless connection between the bridge and the router or access point.

How to factory Reset WET610N?

How can I reset the WET610N to factory defaults? Using the web-based utility, go to Administration > Factory Defaults tab and select YES > click Restore All Settings button to restore it to factory defaults.

What is a wireless bridge adapter?

A wireless bridge or wireless gaming adapter are devices that allow devices to connect to the Internet using a set of paired devices that communicate wirelessly avoiding complicated set-up procedures.

How do I reset my Linksys wes610n?

Reset button – The Reset button is at the bottom of the device. There are two (2) ways in resetting the device to its factory defaults – you can either press and hold the Reset button (using a pin) for five (5) seconds or access the device’s web-based setup page.

What is an Ethernet bridge connection?

Ethernet Bridges are wireless radios that can be used to extend a wireless network to an Ethernet switch or hub (which can be used to extend connectivity to multiple wired devices).

How do you connect to a wireless bridge?

Here’s how to do it.

1. Position the bridge. Place the wireless bridge within range of your wireless router’s signal, and also within a cable’s length of your wired devices.
2. Connect the bridge to your network. If your router supports Wi-Fi Protected Setup, or WPS, setup is easy.
3. Plug in network devices.

What is the benefit of bridging network connections?

A bridge allows you to connect two or more network segments together allowing devices to join the network when it’s not possible to connect them directly to a router or switch.