Why is my Primo water dispenser red light blinking?
Why is my Primo water dispenser red light blinking?
A flashing red function light alerts you when your bottle is empty. Replace the bottle as soon as possible. CAUTION: Do not dispense hot, cool or cold water if the red light is flashing as you could empty the tanks and cause the dispenser to overheat. 1.
How do you reset a Primo water dispenser?
Turn all switches to the off position. Unplug the unit. After a few minutes, plug the unit back in, turn the switches back on and give it one hour and recheck the water temperature. If this does not correct the issue, please call our Customer Service Center.
Where is the thermostat on a Primo water dispenser?
The cold water thermostat control is mounted onto the back of your Primo water dispenser. First, unplug your water dispenser from the electrical outlet. Then, make sure the appliance is away from any wall that it might be positioned next to. This is so you will be able to access the backside of the dispenser.
Why is my cold water dispenser not working?
Very often if your water cooler is not working, the problem can be traced to the power supply. So as a first step, check that it is properly plugged in at the wall and the mains power is turned on. If it is switched on but not dispensing water, the next step is to check your water supply.
Why is my water dispenser not working?
Check to see if the tube bringing water in has a little debris screen on it, which may have gotten clogged. If so, clean the screen to allow water back into the water dispenser. Check the inlet tubing for blockage, and make sure the manual water shut-off valve is clean and clear on the inside.
Can you adjust temp on Primo water dispenser?
The hot water tap on Primo water dispensers is set at the factory and cannot be adjusted. They can provide hot or cold water, depending on the model. Adjusting the temperature of the cold water from a Primo dispenser is easy, and doesn’t require any tools.
How do I fix my refrigerator water dispenser not working?
How to Troubleshoot a Faulty Refrigerator Water Dispenser
- Straighten or Replace the Dispenser Tube.
- Clean Out the Water Lines.
- Inspect and/or Change the Water Filter.
- Test the Water Pressure.
- Defrost the Water Line.
- Check the Pressure Switch.
- Inspect for a Faulty Door Switch.
- Replace the Control Board.
Why is water not coming out of my Primo Water Dispenser?
If water is not coming out from both the taps on your Primo dispenser, it may be due to a faulty seal on a water bottle or an air-lock. To troubleshoot this problem: Check the water bottle before loading it. You can also remove the bottle and check the seal. To remove the air-lock: Remove the air bottle. Empty the reservoir.
What should I do if my Primo Water tank is too full?
The Primo Dispenser usually has a light to show the hot water and cold water. So, if the lights are off, dispense some water, and wait for a few minutes. The tank may also be too full, so you can drain some water for you to get cold water.
How often should I Clean my Primo Water Dispenser?
To solve related problems check at Best Bottom Loading Water Dispensers. Make sure you clean your dispenser every 3-4 months. While you are cleaning, do not remove the top cover of the dispenser as it is attached with a precision sealed gasket and it can result in leakage.
How do you replace a Primo water bottle?
A blinking red light alerts you when your bottle is empty. Replace the bottle as soon as possible when you get this alert code. Follow the steps below to replace the bottle: Open your dispenser door and slide the empty bottle out of the cabinet.
